spinecad Posted May 14, 2013 Share Posted May 14, 2013 Why it does not forming a solid when I already set the mode into solid? Also, how to remove the grid display when lofting? Thank you Quote Link to comment Share on other sites More sharing options...
mikekmx Posted May 14, 2013 Share Posted May 14, 2013 grid lines cos they are planar surfaces i think. like you said, you don't have a solid. most likely the rhomboids (?) you lofted were not drawn with closed polylines. Quote Link to comment Share on other sites More sharing options...
spinecad Posted May 14, 2013 Author Share Posted May 14, 2013 grid lines cos they are planar surfaces i think. like you said, you don't have a solid. most likely the oblongs you lofted were not drawn with closed polylines. It's not an oblong. It's a region. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.