Jump to content

Lost ability to type in measurements

brittany_tate

By brittany_tate
in AutoCAD 2D Drafting, Object Properties & Interface

 Share

Recommended Posts

brittany_tate Newbie

brittany_tate

Posted
Posted

Hi all-

I've always lurked this site to have my questions answered, but I finally hit a problem I haven't been able to search.

 

I opened up my AutoCAD LT 2010 this morning at work and went to work on an existing file only to notice I have lost the ability to type in measurements. Meaning, when I go to draw a line I don't have that option to just type in 2.00 or whatever measurement I need. Same with drawing a rectangle or fillet; the down arrow prompt has dissappeared and I no longer can specify length by width (or radius/dia with fillet). Did I accidently hit something to cause this to dissappear? Is there a trick to get this back?

 

Thanks!

Link to comment
Share on other sites
brittany_tate Newbie

brittany_tate

Posted
  • Author
Posted

:oops:Should have waited to post. I have solved my own problem.

"Dynamic input" was turned off.

 

Thanks to anyone who may have been looking into this for me.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...