Faouweb Posted August 26, 2013 Share Posted August 26, 2013 (edited) Hi, I want to put a text below some drawing, and i can't find how to center the text as you can see in the picture: I use Inventor 2013 Thank you. Edited August 26, 2013 by Faouweb Quote Link to comment Share on other sites More sharing options...
Faouweb Posted August 26, 2013 Author Share Posted August 26, 2013 I have tried with showing X Axis but t's not a good methode Is there any snap tools as it's in AutoCAD? Quote Link to comment Share on other sites More sharing options...
Faouweb Posted August 27, 2013 Author Share Posted August 27, 2013 How can i put the text in the center of the rectangle? Is it possible? Quote Link to comment Share on other sites More sharing options...
JD Mather Posted August 27, 2013 Share Posted August 27, 2013 Partly depends on what you want to do. In Drawing Resouces right click and create new Sketch Block. Create a piece of text and right click on it and select Text Box. Create Sketch Only construction lines and a point for anchor. Quote Link to comment Share on other sites More sharing options...
Faouweb Posted August 28, 2013 Author Share Posted August 28, 2013 Thank you very much Mather. In Drawing Resouces right click and create new Sketch Block. I dont see create new Stetch Block. (I use Inventor Professional 2013) Quote Link to comment Share on other sites More sharing options...
Faouweb Posted September 19, 2013 Author Share Posted September 19, 2013 Thank you very much JD Mather Very helpfull tool Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.