Jump to content

Create aligned CS line with increasing Chainage Number and Name


hellboy2703

Recommended Posts

Hi guys,

i am new here, with a basic question,

 

i need to Create aligned CS line with increasing Chainage Number and Name through a center line (yellow line). The CS lines are 25 meter apart, it can be done by ME command, but can not automatically increase the Chainage number and CS number.

 

 

the CS number (CS-1200) is increasing by 1, like CS-1200, CS-1201, CS-1202, ....

 

also The chainage number (CH Km 29+975) is increased by 25, Example: CH Km 29+975 , CH Km 30+000, CH Km 30+025, CH Km 30+050....

 

i would like to do it automatically, otherwise i have to keep editing for a long time,

 

i have attached a file, where i showed the center line of a rail line, and sample format it needed to be done.

 

Can any one please help me? how can i do it?

 

Thanks in advance

 

Drawing2.dwg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...