Dj_T_Rex2002 Posted September 3, 2013 Share Posted September 3, 2013 Ok wasn't sure where to post my question. I need help with a block I created please (Attached). Is there a Geometric Constraint that can keep the two lines (red and green) keep touching the blue one and look like the drawing right below the block that is Exploded? Thank you. Panel Test.dwg Quote Link to comment Share on other sites More sharing options...
ReMark Posted September 3, 2013 Share Posted September 3, 2013 Dj: This thread is about dynamic blocks while yours happens to be about geometric constraints. Besides which it is not good form to hijack the thread of another forum member. Please bear that in mind in the future. Thank you. Quote Link to comment Share on other sites More sharing options...
Dj_T_Rex2002 Posted September 3, 2013 Author Share Posted September 3, 2013 My apologies. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.