David D Posted September 6, 2013 Share Posted September 6, 2013 I have AC 2010 LT. I have added a printer which is actually a driver for a laser cutting machine. I have been able to add the cutom media size of the machine. I cannot get that size to stick with the printer name. Every time I choose that printer I have to reset the media to the custom size. Any ideas what I am doing wrong? Quote Link to comment Share on other sites More sharing options...
CADgirl Posted September 6, 2013 Share Posted September 6, 2013 You're setting this up with page setup manager? Quote Link to comment Share on other sites More sharing options...
Tuns Posted September 6, 2013 Share Posted September 6, 2013 You can make a page setup with all of the settings you need. Will "previous plot" not use the same size as you had the last time? Quote Link to comment Share on other sites More sharing options...
eldon Posted September 7, 2013 Share Posted September 7, 2013 Are you "Saving the changes to Layout"? - (tick box in the Plot dialogue box) Quote Link to comment Share on other sites More sharing options...
David D Posted September 10, 2013 Author Share Posted September 10, 2013 I think I need some more time to check the situation. Some of the drawings I open have the settings the way I want them and some do not. I need to see if I can determine the pattern before continuing with the thread. Thanks to all for contributions. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.