dadobojanic Posted October 2, 2013 Share Posted October 2, 2013 is it possible to draw dimensions in 3d model view like this I want dimensions in 3d model mode.not in drawing mode. Using inventor2013.Also is it possible to do render with dimensions? also show dimensions is not what i want.i want specific dimensions to be shown Quote Link to comment Share on other sites More sharing options...
JD Mather Posted October 2, 2013 Share Posted October 2, 2013 Is that Autodesk Inventor or is that Inventor Fusion? There used to be an add-in here http://labs.autodesk.com that does what you describe, but I don't think it is available now. Quote Link to comment Share on other sites More sharing options...
dadobojanic Posted October 2, 2013 Author Share Posted October 2, 2013 drawing is from solid edge.and i want to do this in inventor 2013 Quote Link to comment Share on other sites More sharing options...
KennyJ Posted October 2, 2013 Share Posted October 2, 2013 I doubt this is the answer you are looking for because you are not "drawing" the dimensions... but you could show sketch dimensions. Quote Link to comment Share on other sites More sharing options...
dadobojanic Posted October 2, 2013 Author Share Posted October 2, 2013 you mean to show dimensions from draft on 3d model? Quote Link to comment Share on other sites More sharing options...
Lazer Posted October 4, 2013 Share Posted October 4, 2013 I doubt this is the answer you are looking for because you are not "drawing" the dimensions... but you could show sketch dimensions. Ye I use this method, you have to turn the visibility of the sketch on first, this will also turn on the dimensions. From memory dimension visibility turned up in IV2013 so you should be ok. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.