Jump to content

ACADE 2013 Plot set up issue


JBS1959

Recommended Posts

Most of my drawings work fine but a few won't cooperate. I set up the plot to limits.

 

My border base is offset from the border, so the limits are the base to the upper right corner.

 

I set the border base to 0,0

 

With that base offset I get an offset with the border of a B (11x17) size drawing; the left margin has room for a 3 hole punch, so an 11x17 binder doesn't cover up any of the drawing.

 

My issue is some of the drawings ignore the limits and a preview shows a corner of the drawing or the whole drawing without the offset.

 

I'd like to know how to fix this because to insert the components, rungs,wiring,etc. into a border that works is a pain because we use Vault.

 

I don't have permission for some vault commands. (IT dept. rolling eyes)

Link to comment
Share on other sites

  • 1 year later...

Limits plotting Issue solved.

There is a variable called TARGET. If the point of TARGET is set to anything other than 0,0,0 it will mess up limits. In order to reset the TARGET variable to 0,0,0 follow the instructions below.

To set the TARGET system variable back to 0,0,0:

1. Enter dview on the command line.

2. When prompted to select objects, enter all and press ENTER to complete the object selection.

3. Enter points on the command line.

4. Enter 0,0,0 when prompted for the Target.

5. Enter 0,0,1 when prompted for the Camera.

6. Press ENTER again to complete the DVIEW command.

7. Use Zoom Extents to see the entire drawing again.

8. Print or preview the drawing to verify the results.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...