_Anthony Posted November 6, 2013 Share Posted November 6, 2013 In both my 2012 and my 2014 MEP when I try to nwc out it states it is not found. I have used it many times before in 2012, but have not since I installed 2014. I am working with Navis 2014 Quote Link to comment Share on other sites More sharing options...
tzframpton Posted November 6, 2013 Share Posted November 6, 2013 Exporter Plugins installed correctly? Quote Link to comment Share on other sites More sharing options...
_Anthony Posted November 6, 2013 Author Share Posted November 6, 2013 I believe so...even ran repair on them. Was working fine. Think it went bad when I installed MEP 2014 Quote Link to comment Share on other sites More sharing options...
hertz hound Posted November 6, 2013 Share Posted November 6, 2013 I have read in the past about the NWCOUT command. When I tried it a while ago it said "unknown command press F1 for help". So I am curious, do you have to have Navis installed to have that command available? I only have the Freedom viewer. I normally use TeklaBimSight. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.