amard_burn Posted November 7, 2013 Share Posted November 7, 2013 im drawing by using spline and cannot extrude into solid after I change the height along z axis..how can i make it into solid? here my drawing.. i try using loft but also give surface loft Drawing4.dwg Quote Link to comment Share on other sites More sharing options...
MSasu Posted November 7, 2013 Share Posted November 7, 2013 You will need a closed contour in order to get a solid. Please check SPLINEDIT command. Quote Link to comment Share on other sites More sharing options...
ReMark Posted November 7, 2013 Share Posted November 7, 2013 (edited) You can use the PRESSPULL command to give your profile a height. Works on lines, arcs, polylines and splines. Edited November 7, 2013 by ReMark Quote Link to comment Share on other sites More sharing options...
amard_burn Posted November 11, 2013 Author Share Posted November 11, 2013 thank you guys...really helpful.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.