Jump to content

Alignment from Pressure Network - no radius in the Alignment?


Tiger

Recommended Posts

Hey folks,

 

I am trying to make changes to the command Create Alignment from Pressure Network, but I can't seem to make it not put arcs in the alignment? The only reason I need the alignment is to create my profile, and I really don't need an alignment with arcs in it! I know I can create an alignment and snap it to the pressure network, but since the command Create from Pressure Network is so handy, I would sure like to use it - if I can just get it to remove the arcs..

 

Anyone know how to do it?

 

TIA!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...