Jump to content

degrees


Agapi

Recommended Posts

Hey everyone, i am new here.

I am new to autocad and needing help...

 

i made a circle because i am trying to make an auditorium and i am trying to find 0.5590 degrees but i can not...

 

basicaly i need to divide the circle into eaqual pieces Please have a look in the image. Does someone know how can i do that??

 

Thank you very much!!!

circle.jpg

Link to comment
Share on other sites

First set your angle precision to four decimal places in UNITS.

 

Then draw a line equal to the radius of your circle at an angle of 0.5590 which can be done via the command line. In the example below the length of the line representing the radius is 2. Type the input exactly as shown.

Command: Line

 

Specify first point: cen (for center of circle)

Specify next point or [undo]: @2.0

Link to comment
Share on other sites

I tried but I had no result maybe because I do not know how to draw @ point. Is there any other way that I can make the angle without the @point??

Link to comment
Share on other sites

Once you have your precision set high enough, you can polar array your circle into equal chunks. Even at a 100 foot radius this angle is only going to give you about 12" between points on the circumference of the circle.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...