Jump to content

I want to add a macro using a spline command...i think?


spaulus

Recommended Posts

I keep doing the same commands over and over and I think i can use a macro to take some of the work out of my repetitive task.

 

I pick "spline" and then type "near" (osnap), pick the first object then pick a spot in space then type "near" (osnap) and pick last object (end of routine).

 

so would the macro look something like:

 

^C^C_spline;near;\\near;\;

 

Thanks,

Steve

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...