irishobo Posted March 21, 2014 Share Posted March 21, 2014 I am trying to place a table top on a frame I assembled. The edges on the frame have a fillet. I have been able to get 2 of the 3 constraints using the flat cut ends, but the last needs to be constrained to the fillet edge. 80_20_TABLE_1010.zip Quote Link to comment Share on other sites More sharing options...
JD Mather Posted March 21, 2014 Share Posted March 21, 2014 Forget the fillets - they are irrelevant. Mate - Flush the planar side (vertical) of the table top to the planar side (vertical) of the frame member. Also, have you installed all Service Packs and Updates for your release of Inventor (the answer is no). Quote Link to comment Share on other sites More sharing options...
irishobo Posted March 21, 2014 Author Share Posted March 21, 2014 Thank you very much! That worked perfectly. I will check my update status when I get home. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.