Holford Posted April 11, 2014 Share Posted April 11, 2014 Having recently upgraded to ACAD 2014 when closing block editor or completing a hatch command the drawing automatically regenerates but zooms in to the origin point of the drawing (i.e. coordinate 0,0) rather than regerating to the last zoomed area. Is there an automatic setting to counteract this as it's anoying having to 'Z' - 'P' to zoom to previous each time when completing a hatch or block. Regards Holford Quote Link to comment Share on other sites More sharing options...
Holford Posted April 11, 2014 Author Share Posted April 11, 2014 Type USCFollow and reset to 0 rather than 1. Thanks for the advanced search options of the membership site and Welshwil for the original answer to this quirk (some years back)! Regards Holford Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.