Guest kruuger Posted May 19, 2014 Share Posted May 19, 2014 hello is there any way to create part like in attached file and add tabs on each side so part can be correctly unfolded ? need dxf shape. there are two thickness 2, 3 which are very important. i think they are complicate a little since we can build sketch on sides. thanks kruuger 123.ipt Quote Link to comment Share on other sites More sharing options...
JD Mather Posted May 19, 2014 Share Posted May 19, 2014 Sketch1 is not fully defined. What is the angle? Quote Link to comment Share on other sites More sharing options...
Guest kruuger Posted May 19, 2014 Share Posted May 19, 2014 Sketch1 is not fully defined.What is the angle? there will be a lot of parts one above another. it is just an example attached is surface work. now work on solids. hundreds of parts. kruuger Quote Link to comment Share on other sites More sharing options...
Guest kruuger Posted May 19, 2014 Share Posted May 19, 2014 i think i got this 1. draw tabs on main sketch 2. revolve main sketch 3. trim both ends 4. revolve tabs profile http://forum.cad.pl/download/file.php?id=6773&mode=view any other faster solution still welcome k. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted May 19, 2014 Share Posted May 19, 2014 You do not need to draw a rectangle to get a Contour Roll (conic sheet metal) all you need is a single line. Quote Link to comment Share on other sites More sharing options...
Guest kruuger Posted May 19, 2014 Share Posted May 19, 2014 You do not need to draw a rectangle to get a Contour Roll (conic sheet metal) all you need is a single line. ah yes, that's good. easier and faster. thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.