Jake8090 Posted June 9, 2014 Share Posted June 9, 2014 Does anyone have any suggestions. I have been trying to form a rectangular slot tapered inwards on two sides only into a solid. I have tried the extrude command but this taper's all four sides. I have been trying different approaches to problem without success. I feel sure it must be possible in inventor. If someone can point me in the right direction it would be appreciated Jake8090. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted June 9, 2014 Share Posted June 9, 2014 Face Draft Quote Link to comment Share on other sites More sharing options...
Jake8090 Posted June 9, 2014 Author Share Posted June 9, 2014 Thank you very much JD. Took about an hour or so experimenting but got there eventually Jake8090 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.