phyro222 Posted July 16, 2014 Share Posted July 16, 2014 Good Morning, I'm doing a cover for a mixer and I can't develop it. The piece with yellow lines (radial section) of the two lower corners. I can't make a break in those sections. When I try to give an angle of 88.9 ° (not 90 ° like the piece of the picture) dont work, and cannot do the flat pattern. Does anyone know how to do? Thanks in advance. Buenos días, Estoy haciendo una tapa para un Mezclador y no puedo desarrollarlo. La pieza de las lineas amarillas (sección radial en CURVA DE CONTORNO) de las dos esquinas inferiores son las que me impiden hacer el desarrollo ya que no puedo hacer una rotura en esas secciones. Cuando intento darle un angulo de 88.9° (no de 90° como esta en la pieza) en la operación curva de contorno tampoco me lo desarrolla. ¿Alguien sabe como hacerlo? Gracias de antemano. TAPA LATERAL OP_063_14.ipt Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.