Jump to content

Autocad mechanical 2012 bom


mknutsen

Recommended Posts

I am trying to create a BOM within a drawing master that when I close the drawing and re-open it will continue to add and subtract parts and other block items. My question is, Is there a setup manual for creating a bom from start to finish for Autocad Mechanical 2012. Mainly looking for if there are special settings and requirements before I even get started. I should say that I have been able to create the Bom im looking for in a single drawing but after i close the drawing I am not able to open it again and have it calculate the parts like it did before. Any help would be greatly appreciated. Thank you.

Link to comment
Share on other sites

I must not have asked the right question, or maybe nobody has had this problem since there were no replys. I cant seem to find any manuals that describe the BOM process from start to finish. Any ideas or help would be great. Thanks

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...