Jump to content

level of detail


stuartlowes

Recommended Posts

good morning fellas

 

 

right, I am at the end of my tether with an issue on inventor

 

 

one of my inventor users is have great difficulty with a DWG, He is using a custom level of detail in a particularly large IAM and I believe that this is causing him issues when it comes to creating his DWG.

 

 

I believe and as yet have not been able to confirm this that inventor dwg parts lists default to the Master level of detail within the IAM, I also suspect that inventor struggles to read two separate level of details at the same time. I am not saying it cannot do it however it does seem to struggle. can anybody please help me out to either convince me otherwise so I can go down a different route of investigation or to convince my staff member that he needs to use view reps rather than level of detail (I am going to say at this stage in the future rather than on this particular drawing for now as its time critical)

 

 

thanks in advance for your views and opinions.

 

 

stuart

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...