Jump to content

Tube Routing Problems


Nctukek

Recommended Posts

Hey all!

 

I am relatively new to inventor and am having some difficulty with the Pipe & Tube route function. I would like to have a rigid tube w/ bends & .125" OD go from one fitting to another. The fittings I am using are my own custom fittings (aka not pulled from autodesk). I have tried creating a route inbetween them but every time I click 'finish route' it disappears. Could you please walk me through how to create the type of tubing I want and then how to route it between two existing fittings?

 

Thanks!

-Nctukek

Edited by Nctukek
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...