irishobo Posted August 13, 2014 Share Posted August 13, 2014 I am trying to add a fillet to the top of the two ribs in this .ipt. Inventor says this is to complicated. How should I go about doing this. Thanks in advance! The forum says that my .ipt is too large to upload. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted August 13, 2014 Share Posted August 13, 2014 Find the red End of Part marker at the bottom of the feature tree. Drag the red EOP to the top of the browser hiding all features in the graphics window. Save the file with the EOP in this rolled up state. Right click on the filename and select Send to Compressed (zipped) folder. How big is the resulting *.zip file with the EOP in a rolled up state? Quote Link to comment Share on other sites More sharing options...
irishobo Posted August 13, 2014 Author Share Posted August 13, 2014 Here it is. After moving the EOP I didn't have to zip the file. Yukon_Cover_rolled_up.ipt Quote Link to comment Share on other sites More sharing options...
JD Mather Posted August 13, 2014 Share Posted August 13, 2014 I think I would go back to the source from which this part was derived. I noticed a lot of missing symmetry where I would expect to see symmetry. And, I noticed a lot of unconstrained sketches. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.