abishop Posted August 15, 2014 Share Posted August 15, 2014 Inventor 14............ I am trying to dimension a Diameter to the CL of a hole pattern...... HOW? I am trying to dimension the angle these. How? I have attached .pdf Thanks Andy B CL Circle.pdf Quote Link to comment Share on other sites More sharing options...
abishop Posted August 15, 2014 Author Share Posted August 15, 2014 got it. never mind.................patience Quote Link to comment Share on other sites More sharing options...
gbradley Posted August 15, 2014 Share Posted August 15, 2014 How did you do it? Did you Sketch two lines and then dimension the Angle? Quote Link to comment Share on other sites More sharing options...
abishop Posted August 18, 2014 Author Share Posted August 18, 2014 Click Annotate tab and then use teh Centered Pattern. Good Luck! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.