Jump to content

Surveyor2014

Recommended Posts

Good Afternoon,

I am currently drawing elevations from a point cloud clipping which was acquired by a FARO Scanner.

As I am drawing the elevation from the point cloud data, the point cloud as well as the line work which has been produced, is moving side to side and shifting out of place.

See this link for video of this happening:

 

 

Does anyone know why this is happening and what to do to resolve this issue?

 

Thank you in advance for your help :)

Link to comment
Share on other sites

That happens sometimes after using PAN in 2014. Why, I don't know, but if I press the Esc key a couple of times then it stops. It has nothing with the point cloud.

Link to comment
Share on other sites

It's very hard to tell what you are talking about from the video. It looks like you are panning or orbiting and the graphics are getting out of whack. My guess it is an inadequate video card or RAM issue rather than AutoCAD.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...