Jump to content

Ortho causes pipe to draw in weird angles


Epicurwin

Recommended Posts

Set snapstyl to 0 and it is fixed. I have no idea how these values change randomly by themselves.

 

using autocad mep 2014

 

I have ortho on, but pipes are being drawn at strange angles. It doesn't matter if it is from a existing pipe or a new pipe. The cross hair is also messed up. It is only occurring in one drawing. I have UCS set to world and snapang set to 0. I don't know how it fix this.

Edited by Epicurwin
Link to comment
Share on other sites

When that happens to me with conduit it is because the slope is set to some number. I don't use "sloped conduit" but sometimes it gets sloped and I set it back to zero on the properties palette. I can tell when I see the conduit shooting out of the compass at some strange angle when I am in an ISO viewport.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...