Jump to content

P&id 2014 dumb valves attached to smart lines


RONK79

Recommended Posts

this is for a friend at a different company, her company prohibits these forums at work...

 

in the drawing, a dumb valve was used in the smart drawing as a simple block and now it attached itself to the line its connected to and can not be erased without erasing all the connected components. any ideas how it got attached, or how to un attached it with out deleting and starting over...

Link to comment
Share on other sites

  • 2 weeks later...

ah sorry, i was send to spain for week at my company so didnt get time look further into this.

 

 

this dumb valve, is it block made outside of AutoCAD P&ID? what i mean by this is it a dynamic block create in a other version of AutoCAD P&ID? :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...