Jump to content

Reduce Spacing Between Cross Section Views


kenth

Recommended Posts

Hello, how do I reduce the spacings shown as red lines in the pic?

 

In Toolspace, Settings tab, expand Section View node, expand Commands node, right click on CreateMultipleSectionView Command, and select Edit Command Settings... menu item.

 

In the Edit Command Settings dialog, expand Table Creation node, and if memory severs you modify Table Spacing value.

 

Cheers

Link to comment
Share on other sites

  • 7 years later...

Good afternoon

 

I am a novice in design using civil 3d. can you please tell me which design template do you use because at work i found out they are using Devotec. I would be glad if i was just designing without a template because this is limiting me. When i am doing cross section they come out small while i used 1:250 can you also assist in that regard.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...