cdorn7 Posted October 5, 2014 Share Posted October 5, 2014 Can I import real time data that I am measuring on a real system using Labview into a stress simulation on a model of the system? Basically I have realtime force data in labview gathered from a strain gauge on a simple cantilever beam and I want to apply that force to a simulated model of that beam. The force is a simple concentrated load acting at a known position. So the crux of this is exporting that data from labview into the stress analysis in either AutoCAD or SolidWorks. I feel like this should be fairly simple to do, but I am new to both SolidWorks/AutoCAD and Labview. Any advice/suggestions would be greatly appreciated. Thanks! Quote Link to comment Share on other sites More sharing options...
RobDraw Posted October 5, 2014 Share Posted October 5, 2014 I don't think AutoCAD does stress analysis. A quick look at the overview of Solidworks does not reveal stress analysis. You might want to check out this one from AutoDesk: http://www.autodesk.com/products/nastran/overview Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.