Jump to content

how to trim corner via sheet metal? Inventor 2014


Sengna

Recommended Posts

What tool can i use to trim something like this on the image in .ipt or sheet metal environment? i was looking something like miter tool in assembly environment but i am not on assembly file. Thanks

 

 

Trim SM.jpg

Link to comment
Share on other sites

Well, if modeled correctly, Inventor should have already trimmed that for your.

But since you already have it modeled, the Corner Seam tool sounds like a likely candidate for investigation.

Link to comment
Share on other sites

  • 1 month later...

Not the best of methods but as you are stick with a model that will not update correctly you could convert it back to a part make the cut then convert it back to sheet metal (not the correct workflow by any means but a way round in this case).

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...