blueinspiron Posted October 22, 2014 Share Posted October 22, 2014 I can't seem to find to put figure out the where the put the R0.315 based off of the 0.871 height. And the rest of the radaii are chamfers? Quote Link to comment Share on other sites More sharing options...
rkent Posted October 22, 2014 Share Posted October 22, 2014 Offset either arc (1.764 or 2.394) by .315, where that crosses the .871 horizontal is the center point for the .315 arc. The other dims shown are fillets, start the fillet command, set the radius and pick the arcs. Quote Link to comment Share on other sites More sharing options...
blueinspiron Posted October 22, 2014 Author Share Posted October 22, 2014 Thank you! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.