Jump to content

Center snap in sketch mode to a different part in an assembly


ibreakstuff

Recommended Posts

I am working on this assembly where I need to align a circle on the gold colored part with the grey rod in a different part.

I can not figure out how to get the circle I am drawing to snap to the grey rod in the other part in the assembly.

Can someone tell me what to do to get snaps between parts in assemblies while in sketch mode?

Thanks, Rob

snap%20center.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...