Jump to content

Field / additional format / conversion factor


Recommended Posts

I run Autocad 2010 on Windows XP, eventhough I always had this problem and never could find a solution.

I have a problem when I copy a text with a surface field associated to a polyline. I have a drawing in cm but I need the surfaces to be in m², hence I use a conversion factor. I created the field and associated with the polyline. If I copy the field and associate it with a new polyline, I lose the settings of the conversion factor, so that everytime I copy it I have to reset the conversion factor.

Is there anyway to keep those settings?

 

Thank you

Duccio

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...