Mark_CV3D Posted December 18, 2014 Share Posted December 18, 2014 Hello, I have an alignment drawn as the middle of a new road. It circulates around itself and when I make a profile view to show the pipes along the alignment it shows the pipe that is at the correct station but it also shows the pipe thats on the street paralell to that station. Can I somehow make it only show a pipe once at the place where it is nearest to the alignment or can I have a view offset range for pipes? Please help me, I will be grateful to death! Quote Link to comment Share on other sites More sharing options...
JerryG Posted January 20, 2015 Share Posted January 20, 2015 Not sure what version you are working in but if its 2014 and above you can simply erase the one you don't want to see (on the profile not the actual pipe in plan view) Quote Link to comment Share on other sites More sharing options...
C3D_TomR Posted February 24, 2015 Share Posted February 24, 2015 Another suggestion is to split your profile into separate pieces so that the pipe in question is shown in the profile view of the section where it should be shown and not included in the profile view of the section where the alignment loops back and causes it to appear again. --T Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.