Jump to content

blocks with attributes offset - cannot move using refedit


designerstuart

Recommended Posts

hi all

 

we use blocks with attributes for title blocks in our drawings, and a few times recently the multi-line attributes have been moving from their insertion point.

 

i'm not that knowledgeable about attributes, but i did create these blocks.

 

i have read here that there is a VBA to fix it but do not know how to run this - well, i tried and nothing happened so not sure.

 

do have a look at the attached dwg. it contains the block and a version that has been exploded. i would have thought the attribute xxx zzzzz would be positioned by the drawing_title attribute?

 

basically, all the text should be centrally aligned.

 

thanks for your help

 

merry christmas!

 

Screenshot.jpg

 

Drawing2.dwg

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...