Onetafs Posted February 13, 2015 Share Posted February 13, 2015 Hi! I've been having a problem for quite awhile now with this model, its a chair with a 4mm plywood sheet wrapped around the base of the chair. The plywood sheet act as a backrest for the chair. I seem to lack knowledge of the operation to make it happen. Quote Link to comment Share on other sites More sharing options...
JD Mather Posted February 13, 2015 Share Posted February 13, 2015 Attach the *.ipt file here. Your sketch does not appear to be on a plane tangent to the cone. Not sure of the purpose of WorkPlane1? Taper could be included in the Extrusion1 rather than add FaceDraft. Quote Link to comment Share on other sites More sharing options...
Onetafs Posted February 16, 2015 Author Share Posted February 16, 2015 Chair.ipt The workplane was unnecessary, and "taper" worked fine aswell, thanks. Well, here's the file! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.