Jump to content

Wrapping part around cylinder with a draft


Onetafs

Recommended Posts

Hi! I've been having a problem for quite awhile now with this model, its a chair with a 4mm plywood sheet wrapped around the base of the chair. The plywood sheet act as a backrest for the chair.

 

I seem to lack knowledge of the operation to make it happen.The problem.jpg

Link to comment
Share on other sites

Attach the *.ipt file here.

 

Your sketch does not appear to be on a plane tangent to the cone.

Not sure of the purpose of WorkPlane1?

Taper could be included in the Extrusion1 rather than add FaceDraft.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...