beyondforce Posted February 23, 2015 Share Posted February 23, 2015 Hello there, I'm quit new to Inventor and I hope someone could help me with this annoying challenge. I wan to create a Spur Gear based on a Diameter. I was reading a lot about spur gears, but what I can't figure out is, how to create a spur gear with a specific outside diameter in Inventor. The outside diameter should be 600 mm and the number of teeth around 150. I have tried to play with the Spur Gear tool under the Design tab, but with no luck. I would REALLY appreciate it if someone could help me with that! Cheers, Beyondforce. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.