Jump to content

AutoCAD Mechanical 2015 Trim and Extend


JustPunkin

Recommended Posts

So, I know this is a long shot, but here goes.

 

I have a number of users (myself included) who are struggling with trim and extend in 2015.

 

We draw a line. We draw lines perpendicular to that line, but short of the line. We want to extend them all. We start the extend command; we select the first line, and then we window to select the lines we want to extend. The preview shows them all extending, but some of them do not extend. There seems to be no rhyme or reason for this. I was able to get them to extend by selecting top left to bottom right, but a colleague was unable to get the same result.

 

Some variables:

Edgemode =1

Pickadd = 2 (If pickadd is set to 0, it works, but pickadd at 0 is a horrible option)

 

Not sure what else I should be checking.

 

Oh, and when I tried this in vanilla AutoCAD, it worked fine.

 

Thanks!!! Hope someone knows because I am stumped!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...