Tonybere Posted March 16, 2015 Share Posted March 16, 2015 Hello, I have created a horizontal alignment on my surface and created a vertical profile of that alignment. However, the endpoint chainage station listed on the horiz. alignment is approx. 8 meters less than that of the vertical profile (which is correct). How is this possible if the vert. profile was created from the alignment?!?!? I did not create any chainage equations that I am aware of, but I am an inexperienced user. I would appreciate any thoughts as to where I can look to fix this. Quote Link to comment Share on other sites More sharing options...
Organic Posted March 19, 2015 Share Posted March 19, 2015 Is the horizontal alignment quite long? Quote Link to comment Share on other sites More sharing options...
Tonybere Posted March 19, 2015 Author Share Posted March 19, 2015 A little over 3km. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.