rhgrafix Posted March 19, 2015 Share Posted March 19, 2015 I searched the universe and can't find this answer, Sometimes I find an existing dimension where one end has the node that has been collapsed to the tip of the arrow, I can't figure out how to pull it back off the arrow tip. I use 2011, any ideas? Thanks! R.L. Hamm Quote Link to comment Share on other sites More sharing options...
SLW210 Posted March 19, 2015 Share Posted March 19, 2015 I moved your thread to the AutoCAD 2D Drafting, Object Properties & Interface Forum. If I understand you correctly, just grab the grip on the dimension text and move it, you should now have an extension line. If that doesn't work, the extension line may be turned off, check using properties. If you still can't get it, post a .dwg that has this behavior. Quote Link to comment Share on other sites More sharing options...
RobDraw Posted March 19, 2015 Share Posted March 19, 2015 I searched the universe and can't find this answer That must have taken a while. Welcome back. Quote Link to comment Share on other sites More sharing options...
nestly Posted March 19, 2015 Share Posted March 19, 2015 Following along with SLW's comments, does this illustrate the problem? .... a solution? Quote Link to comment Share on other sites More sharing options...
SLW210 Posted March 20, 2015 Share Posted March 20, 2015 I also forgot to mention, you may also need to select "Keep Dimline with text" under Fit Options. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.