Epicurwin Posted April 7, 2015 Share Posted April 7, 2015 I have a run of conduits that are stacked that I need to raise 5". Is there a way to select the entire group and add 5" to the offset? When selecting all the offset field goes blank because they have different offsets. I then enter in +5" but that moves all the conduit to 5" offset, not what they were +5". Is there some variable that stands for current location? Quote Link to comment Share on other sites More sharing options...
RobDraw Posted April 7, 2015 Share Posted April 7, 2015 Move them up 5" in a section/elevation view. Quote Link to comment Share on other sites More sharing options...
Epicurwin Posted April 8, 2015 Author Share Posted April 8, 2015 That's too simple Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.