Jump to content

Resequence Item Number


JohnS

Recommended Posts

Has any one had a problem with the multiple catalog item number section greying out so the Re-sequence Item Number can't assign an item number?

 

 

In the Component Insert/edit panel the item number is working but the multiple catalog item number is not.

 

 

It seems to be just the drawing set I am working on at the moment, which was working fine yesterday.

 

 

Any ideas on what might have corrupted?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...