Jake8090 Posted April 25, 2015 Share Posted April 25, 2015 Can anyone advise please. I have modelled a wind mill set on a shaft in turn set into a ball bearing. I would like use a joint to show rotation of the blades in a simulation. could anyone advise which joint could be used and where it would be placed.I have been trying for several hours without success (All part of learning curve).Many thanks Jake8090 Quote Link to comment Share on other sites More sharing options...
Lazer Posted April 29, 2015 Share Posted April 29, 2015 As always constrain the joints as you would in real life. Could do with a picture to show what you are looking at Quote Link to comment Share on other sites More sharing options...
Jake8090 Posted April 30, 2015 Author Share Posted April 30, 2015 Thank you Lazer Would have added file to post but not sure how to do this. Could you advise please. JD did help over 12 months ago now but unfortunately as you get older (76) it does not stick like it used to. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.