Greenhey Posted May 15, 2015 Share Posted May 15, 2015 I have created multi body parts in a metric ipt, used the manage tab to make components, made the target assembly metric, now when im in the assembly and inspect (measure) its still in mm but if i open the part from the assembly and measure again the measurement now reads in inches. very frustrating Any help would be appreciated Quote Link to comment Share on other sites More sharing options...
MarkFlayler Posted May 17, 2015 Share Posted May 17, 2015 See your other post I responded to. Quote Link to comment Share on other sites More sharing options...
lulumara Posted May 25, 2015 Share Posted May 25, 2015 Check your assembly by going to Tools/document setting/ change length inches to Millimeter, if it shows inches. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.