90eagleTSI Posted June 16, 2015 Share Posted June 16, 2015 I am trying to figure out if there is a way to create a rule using ilogic to extrude a cylinder from a mid plane in at two randomize distances. I am not to shabby with writing rules as this is new for me can someone assist me with how I should go about doing this and thank you. In result, this will be as I suppress multiple parts the length will adjust accordingly between the two new ends. Thank you Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.