ibreakstuff Posted July 25, 2015 Share Posted July 25, 2015 I have been struggling on how to make this general hex top signet ring. Normally I just revolve and boom the ring is done, but the way the 6 sides blend in with the body of the ring has me confused. Any help would be appreciated. Quote Link to comment Share on other sites More sharing options...
ecshclark Posted July 30, 2015 Share Posted July 30, 2015 Make sketches of the top, front, and side views. Then use those sketches to extrude, revolve, cut, etc... Quote Link to comment Share on other sites More sharing options...
Lazer Posted August 7, 2015 Share Posted August 7, 2015 Not sure of your skill level but revolve is only one of may ways to model I can think of a number of ways to model this ring but keeping to the basics is the way to go. Keep is posted on your progress and good luck Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.