Jump to content

can't target a line alone during making a surface loft


Writz

Recommended Posts

i'm watching a video on youtube of a how to draw a helicopter blade, i understand what is going on in the video, but there is one point i can't follow. right when

.

 

I did exactly everything he did until that point, where i can't target the open loop(the line), instead it targets the sketch(3 lines connected to each other).

 

I attached my last progress file blade5.SLDPRT .. i'm using solidworks 2015 sp2.1

Link to comment
Share on other sites

  • 2 weeks later...

He selects the two endpoints as "profiles" (blue)

The lines (e.g. length of the blades) are both selected using the "Guide Curve" (Purple) selection tool.

 

I think? Thats how I interpret your query :?

Link to comment
Share on other sites

  • 2 months later...

If you need a single line from a sketch you need to right click and use "selection manager". I didn't watch the video but im guessing that is the issue.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...