Jump to content

[HELP] Refine Mesh


Antraxirator

Recommended Posts

Hey guys, I'm pretty new to all this autocad mesh stuff, So I got a question, is it possible to refine object without smoothing it ? I need more grids for measurement of specific places of Object (In my case measured church). So I need lots of grid lines to be able to snap with ruler and measure lengths and heights. All I found was to convert my 3d faces to single object, then convert it to mesh and refine few times to get a dense grid of the object then just explode it or leave it to be. But it requires the object to be smooth level one. So this is not the solution, cause I need object to be as it is now AKA not smoothed.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...