Casio47 Posted December 10, 2015 Share Posted December 10, 2015 Hello I have two rectangles. I want one side of one rectangle (midpoint) to snap to another side of the second rectangle, exactly at that midpoint. I have OSNAP turned on, with midpoints checked, but it's not snapping...what am I doing wrong? Thanks Architecture 2016 Quote Link to comment Share on other sites More sharing options...
rkent Posted December 10, 2015 Share Posted December 10, 2015 You will have to describe your steps to get a better understanding of what you are doing. Quote Link to comment Share on other sites More sharing options...
ReMark Posted December 10, 2015 Share Posted December 10, 2015 Look at your command line for these two prompts in the order shown. Specify basepoint (pick midpoint of first rectangle). Specify second point (pick midpoint of second rectangle). Quote Link to comment Share on other sites More sharing options...
Casio47 Posted December 10, 2015 Author Share Posted December 10, 2015 I type OSNAP and select the snap I want in General section. I then select the rectangle, and slowly drag it to the second rectangle side midpoint, in hopes the two midpoints will snap together, thus snapping the two rectangles together, at the two side midpoints. OK, let me have it...what am I doing wrong...I'm ready. Quote Link to comment Share on other sites More sharing options...
RobDraw Posted December 10, 2015 Share Posted December 10, 2015 Use the move command and follow the prompts. Quote Link to comment Share on other sites More sharing options...
Casio47 Posted December 10, 2015 Author Share Posted December 10, 2015 Oh...That's how it works. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.