is there an option choose path when using helix command?

Hello,

I want to use the path for my helix command but I don´t know how to do that. For example, in sweep command you have options for choosing path. Can I choose path in helix as well? If so, then how?

See the link : http://prntscr.com/9qtgcn

Thanks in advance.

Best regards

There is no option to choose a path that I am aware of.

Command: HELIX

Number of turns = 3.0000 Twist=CCW

Specify center point of base:

Specify base radius or [Diameter] :

Specify top radius or [Diameter] :

Specify helix height or [Axis endpoint/Turns/turn Height/tWist] :

This thread may be of interest: http://www.cadtutor.net/forum/showthread.php?353-Telephone-cord&highlight=telephone+cord

Here's another one: http://www.cadtutor.net/forum/showthread.php?42900-half-round-spring&highlight=telephone+cord

Thank you Cad64. Will look into it.

Best regards to you

There is no option to choose a path that I am aware of.

 

 

 

This thread may be of interest: http://www.cadtutor.net/forum/showthread.php?353-Telephone-cord&highlight=telephone+cord

 

Here's another one: http://www.cadtutor.net/forum/showthread.php?42900-half-round-spring&highlight=telephone+cord

Hereabouts...

Thank you GP_

You're welcome